company news about What is the composition of the PCB splitter?

PCB splitter equipment composition

PCB splitter: It consists of a combined bracket, a liner combined board, a frame support and guide system, a material carrier, a discharge device, a tool and its fixing device, an upper plate support system, and a cutting speed change device. The upper table of the combination bracket is short, the pad combination plate is horizontally fixed on the combination bracket, the pad combination plate has slits corresponding to the number of knives, and the frame support guide system consists of several pairs of guide sliding devices fixed on the combination bracket. and several pairs of positioning devices.

The guide sliding devices are fixed on the two side frames of the combined bracket in pairs, and the positioning devices are also fixed on the two side frames of the combined bracket in pairs.

That is to say, the guide sliding device in the frame support guide system only allows the material carrier to move along the longitudinal axis of the combined support, but restricts its lateral displacement, and the material carrier is located on the guide sliding device

When it moves longitudinally, the positioning device locates the material carrier, the discharge device is fixedly connected with the buffer composite plate, the discharge device has slits corresponding to the number of tools, and the upper plate support system consists of four vertical plates

The tops of the four uprights of the PCB splitter are fixed on the four corners of the rectangular frame, and the bottoms of the four uprights are fixedly connected to the combined bracket. The tool and its fixing device are composed of a tool, a tool fixing plate and a rectangular frame. Multiple tools are arranged and fixed on the tool fixing plate. The entire tool fixing plate is inserted and fixed in the fixing grooves on both sides of the lower part of the rectangular frame by pulling. There are through holes in the four corners of the rectangular frame. The four posts in the upper plate post system pass through these holes. A connecting block is fixed at the geometric center of the rectangular frame, and the connecting block connects the rectangular frame with the lower end of the vertical screw rod, and the upper end of the vertical screw rod is connected with the worm gear mechanism in the gearbox of the cutting transmission device. The cut-off transmission includes the motor, gearbox, control switch, buffer and travel switch. The motor and gearbox are fixed in the center of the rectangular frame of the upper plate column system, the bump is fixed outside the rectangular frame of the cutter fixing device near the column, and the two travel switches and power control switches are installed on the same control board. The upper and lower ends of the control board are respectively fixed on the same column. The motor drives the worm and the worm wheel in the gearbox to rotate through the belt so that the vertical screw drives the tool and its fixing device to move up and down, and the block hits the travel switch to make the travel switch act to control the moving position of the tool, the cutter, and the discharge device. The slit is in a vertical plane with the slit on the seat cushion combination plate