company news about Maintenance and maintenance of the splitter

Due to its many advantages, the splitter has also been widely used in the electronics industry. From LED to the mobile phone PCB board, we use a cutting machine, curve cutting machine, cutter cutting machine and so on. But usually, in the process of use, the main components such as the tool and the spindle will have some loss, so you must pay attention to the maintenance of the shunt during the use process. Let me introduce the experience that you need to use when maintaining the shunt.

1. After the work, the power must be turned off, and cleaning is also very important. If the residue is not removed in time, it may damage the dispenser attachment;

2. Regular maintenance of the appearance, frequent wiping to give people a good visual effect, so that the equipment is bright and clean

3. If it is a splitter, always pay attention to the protection of the upper and lower knives. If it is a curve separator, pay attention to the maintenance of the milling cutter;

4. If it does not work for a long time, the upper and lower knives should be removed and oiled for protection. The same is true if it is a milling cutter distributor. Remember to wipe clean before use;

5. If it is found that the tool is damaged, it should be replaced in time, and lubricating oil should be added. A lubricant is a device that reduces friction and wear.

6. At the end of the mid-section plane, pay attention to check the tightening of the screws. If the device vibrates during disassembly, check the screws.