Home News

company news about How to use the splitter

Certification
China Dongguan Yixie Automation Equipment Co., Ltd. certification
China Dongguan Yixie Automation Equipment Co., Ltd. certification
I'm Online Chat Now
Company News
How to use the splitter
Latest company news about How to use the splitter

The splitter usually refers to the PCB splitter, that is, the circuit board splitter. Indexing machines are widely used in the manufacture of electronic products. Since the traditional manual-folding method will generate a lot of stress and seriously affect the product quality, manual-folding has been basically replaced by machines. Below, Martin splitter will share the purpose, structure, and functional characteristics of the splitter!

 

How to use the splitter:

 

1. The operator should install some high-frequency goggles, which can not only effectively protect the operator's eyes, but also effectively improve the operator's operating speed and quality. The cutting of industrial sheets not only requires wearing goggles under the stimulation of some strong light but also in order to effectively prevent some dust and impurities from entering the eyes and affecting the operator's cutting work, use goggles to operate the PCB distributor. This is also very necessary.

 

2. When using the knife-type slitting machine, some safety devices should be properly installed to effectively avoid injury caused by human negligence. After all, no matter how carefully people work, occasional oversights are inevitable. In addition, after safe installation, it can not only effectively protect the safety of operators, but also ensure the quality of products.

 

3. When adjusting the cutting distance, not only should it be done according to the standard of the product to be cut, but it should also be operated correctly when using the knife classifier, otherwise it will be difficult to achieve the effect.

 

4. After the above steps are adjusted, start dividing. First, put the V-groove of the PCB board into the PCB splitter, and then press the foot switch to split the board. Remember: the PCB does not move during the cutting process. The circular knife slides to ensure that the electronic components of the substrate are not affected by movement. If it is damaged, turn on the power and set the knife feeding stroke (determined by the size of the PCB) and speed (run at low speed when the speed light is green, otherwise run at high speed);

 

5. Insert one end of the power cord into the power socket of the fuselage, and connect the other end to the 220V AC power supply; connect the foot switch to the foot switch socket, and do not turn on the power switch temporarily; Ground to prevent static electricity; after each operation, remove the sundries on the machine; if it is not used for a long time, you need to apply protective oil to the upper and lower knives to prevent rust, and add lubricating oil to the slide rails.

 

For more information about the splitter, please call Dongguan Yixie Automation Equipment Co., Ltd. We not only have professional products but also considerate after-sales service. We sincerely welcome new and old customers to inquire and purchase.

Pub Time : 2022-06-16 14:34:39 >> News list
Contact Details
Dongguan Yixie Automation Equipment Co., Ltd.

Contact Person: Mr. Wen

Tel: 13925736504

Fax: 86-0769-85302232

Send your inquiry directly to us (0 / 3000)