company news about Debugging of fully automatic splitter

At present, in the field of intelligent sub-board machines, sub-board technology has developed rapidly, and a hundred flowers are blooming in the sub-board machine industry. How to choose a splitter and how to choose a splitter suitable for its own process products is very important for electronic equipment manufacturers involved in this field. Of course, the debugging of the fully automatic sub-board machine involved has also become the object of attention. Next, let's introduce the specific process of debugging our automatic splitter. During the commissioning process, attention should be paid to the position of the blades and whether the parts on the circuit board will collide with the body. The specific operation process includes:

1. When we confirm that the parts on the circuit board will not collide with the body, and the relevant dimensions on the machine and the parts on the circuit board will not exceed the acceptable range, we can safely and efficiently complete the debugging of the automatic splitter.

2. Secondly, in the internal division of the machine, we should ensure that the circuit board is accurately divided along the V-shaped groove on the circuit board. Of course, this also depends on whether the height adjustment of the upper guide plate is correct. If the operation is improper and the circuit board is used too high, it will not be able to be correctly fed into the machine along with the V-shaped cutout, resulting in the circuit board jumping, resulting in low efficiency and poor process quality. Therefore, before use, the position of the upper guide knife should be adjusted according to the thickness of the divided circuit board and the depth of the V-shaped groove on the board. Methods as below:

First, when dealing with this problem, you should power off the machine, take out the circuit board to be split, and lay it flat on the external support plate. Clamp the board's V-notch slot on the guide knife and push it smoothly toward the cutting blade in the machine until it touches the round blade. At this time, loosen the upper guide knife fixing knob to facilitate the adjustment of the upper guide knife. Adjust the upper guide knife to the appropriate height. At this time, the V-shaped groove on the circuit board is not only stuck by the upper and lower guide knives, but also can be positioned correctly without jumping out left and right, and can also slide flexibly along the guide plate.

3. Blade spacing adjustment: After the circuit board is fed into the machine along with the guide plate, whether the blades can separate it neatly, and whether the stress during the splitting process is minimized, depends on whether the spacing between the upper and lower circular knives of groups a, B, and C is appropriate. . Therefore, the blade spacing should be adjusted according to the thickness and material of the divided circuit board. In order to achieve high-quality results.